Delmhorst-instrument Navigator Manuel d'utilisateur télécharger pdf (Page 12)

Page 12 of 28

Use the ï ð keys to toggle between residential and commercial. After you have made your

selection, highlight DONE and press SELECT.

Please refer to Appendix A for a list of location definitions for residential jobs.

TO SET THE ID NUMBER:

The ID field will display the last selected ID number. Press SELECT on “ID” to enter the ID

screen

Select any number between 0 and 999 as the ID of your job, using the ï ð keys. Press the

SELECT key after choosing the ID#.

TO SET TEMPERATURE CORRECTION:

Navigator defaults to a temperature of 70ºF. As wood temperature increases, its electrical

resistance decreases and indicated moisture content rises. Lower wood temperatures result in

lower indicated moisture content. A correction is necessary if the wood temperature is outside

the range of 50ºF (10ºC) to 90ºF (32ºC). Set the temperature accordingly and the meter will

make the correction.

1. To change the temperature, use the ñ ò keys from the CREATE JOB sub menu to

highlight the temperature, T: 70ºF.

2. Press the SELECT key to enter the COMP TEMP sub menu.

3. Using the ï ð keys, scroll up or down to a higher or lower temperature value.

Temperature values will change in 5º F increments.

4. To change between C and F, press the SELECT key when the COMP TEMP is highlighted.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Delmhorst-instrument Navigator Manuel d'utilisateur Page 12